Nearly 875 standard UniSlide models are available. But sometimes, the standard versions just won’t suit your application. We understand. That’s why we offer a wide range of custom modification capabilities, including these:

• Additional holes or slots. Please send us a sketch.
• Additional sliders or multiple sliders
• Intermediate plates to mount your payload
• Different knobs Show me knobs.
• Special or in between lengths of the dovetail base
• Deeper bases, using the “B” base cross-sections for greater stiffness
• Lead screw shaft extensions
• Vacuum preparation.More
• Optional finishes : black, hard coat, nickel and more.
• Choice of lead screw materials, including brass
• Choice of drive nut materials, including brass and Vespel
• Right angle Gearbox to bring control to the side
• Right and left-hand threads on the same lead screw, allowing a pair of sliders to move together or apart
  
  Still don’t see what you want? Give us a call. If it can be done with BiSlides or UniSlides, we can do it.

Right and left-hand threads on the same lead screw, allowing a pair of sliders to move together or apart	Photo 1: A deeper bases, using the “B” base cross-sections increases unsupported base stiffness
	Photo 2: Additional holes in end of dovetail base and slider
	Photo 3: Two end bearing blocks for greater support of long lead screws
	Photo 4: Slider to slider mounting. Ganged UniSlides with special end block plate.
	Photo 5: Right angle gear drive
	Photo 6: Multiple slides on the same base. More
	Photo 7: Series A15 with special small diameter Graduated Knob. Other knobs are available.
	Photo 8: Ultra small linear, elevating and non ferous rotary table
Photo 9: Parallel coupled with timing belt A40 Series UniSlide.
Photo 10: Two Sliders, two lead screws on a single A60 dovetail base Go to top of page Photo 11 This intermediate plate is used to mount the payload. Plate can have indexing holes, through holes or threaded holes. Send us a sketch of your plan for an estimate. Go to top of page